wow Lv1Posted Dec-27-2024 09:17
  
Support but from HCI version should be 6.3
AlexanderSeba Lv3Posted Dec-27-2024 11:12
  
LACP can be used with Sangfor HCI on production networks; ensure accurate settings on HCI and the switch.
Aries Lv4Posted Dec-27-2024 11:12
  
Sangfor HCI allows LACP for non-storage links; verify configuration consistency on both HCI and switch.
handra Lv2Posted Dec-27-2024 11:13
  
Can non-storage (Manage/Production) link aggregation support LACP protocol?
Yes, LACP is supported by Sangfor HCI for Manage/Production networks; ensure all settings are accurate.
Daeng Posted Dec-27-2024 11:13
  
Sangfor HCI supports LACP for production links; align configurations on both HCI and the connected switch.
Ryutope Lv2Posted Dec-27-2024 11:15
  
LACP is compatible with Sangfor HCI non-storage networks; confirm proper setup on the HCI and the switch.
JJ Teoh Lv1Posted Dec-27-2024 14:37
  
Yes, can support static LACP protocol starting from version HCI6.8.0 but Dynamic LACP is not supported.
Newbie205940 Lv1Posted Dec-27-2024 14:41
  
Yes, in HCI, non-storage networks (Management/Production) can support the LACP protocol starting from HCI standard version 6.8.0. However, it supports only static LACP, not dynamic LACP. This allows for link aggregation and load balancing, enhancing reliability and ensuring continuous data transmission in case of link failure.
Newbie766194 Lv1Posted Dec-27-2024 17:13
  
Yes, It is support to configure static LACP
Imran Tahir Lv4Posted Dec-29-2024 00:43
  
Nope it's not supported