1. Access the IPMI Web Interface
a) Connect your computer to the same network as the IPMI.
b) Open a web browser and enter the default IP address (usually http://192.168.1.100 or as specified in your server documentation).
c) Log in using the default credentials:
d) Username: admin
e) Password: admin (or as specified in your documentation).

2. Navigate to Network Settings
a) After logging in, go to the "Configuration" or "Network" tab, depending on the interface.
b) Locate the "LAN" or "Network Settings" section.

3. Change the IP Address
a) Select Static IP if you want to assign a new static IP, or DHCP if you want the IPMI to be assigned an IP address automatically.
b) For Static IP:
Enter the new IP address, Subnet Mask, and Default Gateway.

4. Save the Configuration
a) Click Apply or Save to confirm the changes.
b) The IPMI will apply the new settings, and the interface may require a restart.

5. Verify the Change
After the IPMI reboots, access it using the new IP address you just set to confirm the change was successful.

If you're using ipmitool via the command line:

• Run the following commands to set the new IP:
  
  
  

ipmitool lan set 1 ipaddr <new-ip-address>

ipmitool lan set 1 netmask <subnet-mask>

ipmitool lan set 1 defgw ipaddr <gateway-ip>

   2. Verify the settings:

ipmitool lan print 1

Access the IPMI interface through its default IP, go to Network Settings, update the IP configuration, and save to apply changes.

Open the IPMI web console using its default IP, find the Configuration or Network section, change the IP details, and reboot if necessary.

Log in to the IPMI using the factory-set IP, navigate to Network Configuration, modify the IP address, and save the changes.

Use the default IP to access the IPMI settings, adjust the network settings under Configuration, and apply the new address.

Connect to the IPMI via its default IP, update the IP, mask, and gateway in the Network Settings, and save.

Access the default IPMI address in a browser, find the Network tab, change the IP, and restart if prompted.

Log into the IPMI default interface, locate Network Settings, update the IP information, and confirm.

Open the IPMI console at its default address, change the IP details under Network Configuration, and save.

Use a browser to access the default IPMI address, adjust the IP settings in the Network section, and apply changes.