Enrico Vanzetto Lv4Posted Dec-31-2024 06:18
  
Hi, press del on boot to enter bios settings. there'sa section called ipmi. Here you can change ip address.
Rendy Rinaldy Lv2Posted Dec-31-2024 09:26
  
Step 1. Connect a PC/Notebook to Sangfor aServer IPMI/Mgmt network port with RJ45 Ethernet. The IPMI network port should be labeled with IPMI or Mgmt.
Step 2. Configure notebook/PC network interfaces to any IP of 192.168.10.x/24 (EXCEPT 192.168.10.10).
Step 3. Open web browser and access IPMI with default IP http://192.168.10.10 .
Step 4. Possible login credentials (username/password):

• ADMIN / 11111111.

• ADMIN / ADMIN.

• Sangfor / ADMIN.

• admin / admin.
Step 5. Access IPMI dashboard.
ArsalanAli Lv3Posted Dec-31-2024 14:09
  
change the default IP by NGAF Web management interface

or

by Installing the IPMITOOL utility
access the command line interface , then use IPMITOOL LAN SET command
Prosi Lv3Posted Dec-31-2024 21:43
  
Connect and log in using the default to the aServer IPMI; Change the IP Address to the desired values; Save the settings and reboot.
Newbie362074 Lv3Posted Dec-31-2024 22:52
  
Upon first login, administrator will be prompted to modify default IP address
AimanHakim Lv2Posted Dec-31-2024 23:28
  
Access IPMI system and change the IP from the settings
Apriyanto Lv5Posted Jan-01-2025 06:01
  
To change the IPMI default IP on Sangfor HCI, log in via the default IP, go to Network Settings, update the IP, Subnet Mask, and Gateway, then save and reboot if needed. Verify the new IP by pinging it and logging back in. Make sure the new IP doesn’t conflict with other devices.
Sheikh_Shani Lv2Posted Jan-01-2025 22:04
  
To change a server's IPMI default IP address, follow these steps:

1. Connect to the server: Use a computer connected to the same network as the server.

2. Open a web browser: Enter the current IP address of the server’s IPMI interface to access the management interface.

3. Log in: Enter the admin username and password. The default credentials are often "ADMIN" for both, but check your documentation.

4. Find the network settings: Once logged in, look for a section called "Network" or "IPMI Settings."

5. Change the IP address: Enter the new desired IP address, subnet mask, and gateway. Make sure the new IP does not conflict with other devices on the network.

6. Save the changes: Click on the save or apply button to update the settings.

7. Restart the IPMI interface: Sometimes, you might need to restart the server or the IPMI interface for the changes to take effect.

8. Test the new IP: Try accessing the IPMI interface using the new IP address in your web browser.

Make sure to have a backup of your current settings just in case you need to revert.
Dwi Nur Lv2Posted Jan-01-2025 23:39
  
Log in to the BIOS interface, select Server MGMT > BMC Network Configuration > BMC IPv4 network configuration / BMC IPv6 network configuration
pbeugenio Lv2Posted Jan-02-2025 08:23
  
BMC config on BIOS