Newbie290036 Posted 2024-May-03 17:31
  
Configuring failover between two WAN links on Sangfor IAM (Internet Access Management) is a common requirement to ensure network reliability and continuity.

1. Log in to the Sangfor IAM web console using your administrator credentials.

2. Navigate to the WAN Configuration section, usually found under Network Settings or a similar menu option.

3. Locate the settings for WAN links and look for options related to configuring multiple WAN connections or failover.

4. Add both of your WAN links and ensure they are properly configured with the correct IP addresses, gateway, and other necessary details.

5. Look for an option to set up load balancing or failover between the two WAN links. You may need to specify the primary and secondary WAN links for failover scenarios.

6. Configure the failover settings according to your requirements. Typically, you can set up a priority order for the WAN links or specify conditions under which failover should occur (such as link failure detection).

7. Save your settings and test the failover functionality by disconnecting one of the WAN links and observing how the Sangfor IAM device switches over to the backup link.
Farina Ahmed Lv5Posted 2024-May-03 17:33
  
For configuring failover between two WAN links on the IAM Sangfor, it is typically need to access the device's web interface or command line interface and navigate to the WAN configuration settings. From there, one would specify the primary and secondary WAN links, set up monitoring for link availability, and define the failover criteria such as link latency or packet loss thresholds.
Prosi Lv3Posted 2024-May-06 11:45
  
Step 1.Login to Active device. Goto System > Deployment to check first if the IAM devices is already on RouteMode deployment. We will be using the DMZ interface

I Can Help:

Change

Moderator on This Board

1
3
5

Started Topics

Followers

Follow

Board Leaders