Usage of HCI server

i want to ask about the procedure of shutdown the HCI server...thx for the attention

Shut Down -To shut down Sangfor HCI server/machine(s), select one ormore virtual machines and then click on Shut Down.

Administrator can perform the following operation: Shut Down

There are the following tabs: Summary, Snapshot, Backup/CDP,Permissions, Tasks and Alarms, as shown below.

On the Summary tab, you may perform such operations as Power On, ShutDown, etc., and view basic information and hardware configurations of virtual machine.

To shut down Sangfor HCI server/machine, you may click (Ctrl+Alt+Del)then Shut Down.

i know how to shutdown the VMs,

but after that,how can i shutdown the system and hardwares of HCI?

If your using a third party server you can shutdown it like the normally server shutdown

On the Summary Tab you can shutdown the VM

Go to VM Tab and select the desired VM then go to shutdown

do it normally as we do in other product

The specific procedure for shutting down an HCI (Host Controller Interface) server can vary depending on the operating system and the software being used. However, here are some general steps you can follow:

1-Close all active sessions and disconnect any connected devices to the HCI server.

2-Log in to the HCI server using an account with administrative privileges.

3-Stop any running processes or services associated with the HCI server. This may involve using commands such as "systemctl stop hci.service" on Linux or "net stop hci" on Windows.

4-Save any unsaved data or changes to the server.

5-Once all processes and services have been stopped, use the appropriate command to shut down the server. For example, on Linux, you can use the "shutdown" command with the "-h" option to shut down the server immediately. On Windows, you can use the "shutdown" command with the "-s" option to shut down the server.

6-Wait for the server to fully shut down before turning off any hardware.

It is important to note that shutting down an HCI server improperly can result in data loss or corruption, so it is important to follow the appropriate procedures for your specific setup.

1-Close all active sessions and disconnect any connected devices to the HCI server.

2-Log in to the HCI server using an account with administrative privileges.

3-Stop any running processes or services associated with the HCI server. This may involve using commands such as "systemctl stop hci.service" on Linux or "net stop hci" on Windows.

steps you can follow:

1-Close all active sessions and disconnect any connected devices to the HCI server.
2-Log in to the HCI server using an account with administrative privileges.
3-Stop any running processes or services associated with the HCI server. This may involve using commands such as "systemctl stop hci.service" on Linux or "net stop hci" on Windows.
4-Save any unsaved data or changes to the server.
5-Once all processes and services have been stopped, use the appropriate command to shut down the server. For example, on Linux, you can use the "shutdown" command with the "-h" option to shut down the server immediately. On Windows, you can use the "shutdown" command with the "-s" option to shut down the server.
6-Wait for the server to fully shut down before turning off any hardware.