If i use Virtual Wire setup, can i still monitor and block source objects?

Newbie344490 Lv1Posted 2020-Oct-12 10:19

If i use Virtual Wire setup, can i still monitor and block source objects/network? thanks

By solving this question, you may help 989 user(s).

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

KY Lv3Posted 2020-Oct-15 14:27
  
May I know what product you referring? If you are using NGAF and deploy in virtual wire mode, then the access control still support in the deployment mode
Ellechar Lv4Posted 2021-Jan-08 10:53
  
Very Nice Information
Newbie623281 Lv1Posted 2021-Feb-20 05:41
  
im also looking for this solution.
Faisal Posted 2021-Apr-22 11:36
  
Last edited by Faisal P 21 Jul 2022 14:26.

You can set the specific user or IP address in the Objects pane. See the following figure.

This topic contains more resources

You must log in to download or view the file. Not registered yet? Register

x
Fida_Balti Lv4Posted 2021-Sep-24 12:40
  
Very informative ...
Fida_Balti Lv4Posted 2021-Sep-24 13:34
  
Very Nice Information
Sami Lv1Posted 2021-Oct-02 06:11
  
Dear Sir,

Yes you can control traffic in VW mode, from two ports (LAN<-->WAN) or Second VW Group (LAN<-->DMZ).
It works based on Physical port pairs.

Thanks & regards
ANNAL Posted 2022-May-26 05:17
  
I've been looking for some nice stuff regarding the matter and haven't had any karma up until this point,

kmrnliaqat Lv3Posted 2022-Jun-01 18:23
  
informative ..

I Can Help:

Change

Moderator on This Board

1
152
3

Started Topics

Followers

Follow

1009
209
99

Started Topics

Followers

Follow

Board Leaders