Configuration Guide# How to Configure Aggregated Interfaces for Sangfor NGAF V8.0.47

Product: NGAF

Version: 8.0.47

1. Introduction

1.1 Scenario

In a real-world scenario, the connection between the Core Switch and the Firewall consists only of a single line. This leads to a single point of failure and when this connection fails, there will be a downtime on the internal network. To address this issue, we need to aggregate interfaces and in this article, the Sangfor NGAF will be configured to combine the two interfaces.

1.2 Benefits of Aggregated Interface

1) Increase Bandwidth

2) Load balancing

3) Redundancy and High Availability

4) Fault tolerance

5) Improve performance

2. Configuration Guide

2.1 NGAF Configuration

Details:

• 1. The type of connection  between Sangfor NGAF and Core Switch is Layer 3
• 2. The IP Address subnet used is 172.28.3.0/24
• 3. The interfaces on the Sangfor NGAF that will used in aggregation are eth4 and eth5
  
  

Step 1.

Go to Network > Interfaces > Aggregate Interface and click Add, as shown below:

Step 2. A new window will pop up when you click the Add Button. Then put the following details:

• Name: 1
• Description: Aggregate Link to Core Switch
• Type: Layer 3
• Zone: LAN
• Work Mode: Load balancing – RR
• Select Member Interfaces: eth4 and eth5
• IPV4
• Static IP: 172.28.3.1/24
• Next-Hop IP: 172.28.3.2
• Allow: WEBUI, PING, SSH
  
  

Then click Save.

Step 3. Verify the newly created Aggregated Interfaces as shown below:

Step 4. Verify the connections between Core Switch and Sangfor NGAF

Ping: Core Switch to Sangfor NGAF

3. Other Details

1). The type can be Layer 2. It depends on the network

2). The work mode can also be active-passive and LACP.

--------------------------------------- This article is contributed by    ------------------------------

Wanna get to know him? Click here.

Thank you @Regiboy for taking the time to create a nice configuration guide for us. 4000 coins will be rewarded for your contribution.

We warmly welcome engineers to share your creations like configuration guides or troubleshooting cases with us. Each article will be rewarded with at least 4000 coins.

For more details please click here: https://community.sangfor.com/forum.php?mod=viewthread&tid=7706

Very well explained

This scenario was amazing and even it is very easy to understand via diagrams.

thanks for sharing