How to assign WEB UI to other Interface in IAG?
For Example:
These are my Interfaces and currently, I can login to the WEB UI using default eth0 -10.251.251.251


Now I want to enable WEB UI on eth2 and use this IP - 192.168.1.40

Johnbada has solved this question and earned 20 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

Hope we have the same version IAG firmware.

since the ETH2 is sign as zone WAN then you can do the following step:

1. Goto  System >> General >> Advance
2. Select option Remote Tech Support the enable the Enable admin access via WAN interface

sample picture as below:

hope this can solved your problem.
Is this answer helpful?
SassyScorpio Lv2Posted 20 Mar 2023 13:05
  
IAG, or Intelligent Application Gateway, is a Microsoft product that provides secure remote access to corporate resources. Assigning a web UI to another interface in IAG can be done through the following steps:
  • Open the IAG Management Console.
  • Navigate to the "Configuration" tab.
  • Select the "Network" option from the left-hand menu.
  • Click on the interface you want to assign the web UI to.
  • Under the "HTTP(S) Server" section, click on the "Change Settings" button.
  • In the "Server Configuration" dialog box, select the "Use a custom web site" option.
  • Enter the IP address and port number of the web server you want to use for the web UI.
  • Click on the "OK" button to save the changes.


Once you have completed these steps, the web UI will be accessible through the IP address and port number you specified.
Johnbada Lv2Posted 20 Mar 2023 18:54
  
Hope we have the same version IAG firmware.

since the ETH2 is sign as zone WAN then you can do the following step:

1. Goto  System >> General >> Advance
2. Select option Remote Tech Support the enable the Enable admin access via WAN interface

sample picture as below:

hope this can solved your problem.
rivsy Lv5Posted 21 Mar 2023 09:18
  
You can set it in the WAN interface
Jhazz Lv3Posted 21 Mar 2023 09:33
  
You can enabled it thru the "Remote Tech Support" under General and Advance tab
Faisal Piliang Lv8Posted 23 Mar 2023 17:34
  
After finishing all the wiring, you can then log into the Web User Interface (UI) to configure the. SANGFOR IAM device.

I Can Help:

Change

Moderator on This Board

15
24
3

Started Topics

Followers

Follow

1
2
5

Started Topics

Followers

Follow

Board Leaders