Configuring Basic DNAT 6 to 4
  

RegiBoy Lv5Posted 17 Oct 2022 13:30

# Configuration Guide# Configuring Basic DNAT 6 to 4
*Product: NGAF
*Version:8.0.47

*1. Introduction

1.1 Scenario

NGAF deploy as a internet gateway and connect a layer 3switch. Internal network have PC and server.
1.   ServerIP: 192.168.1.10/24
2.   InternetIP: 2003::1/64
3.   UserIP: 2003::2/64
Topology:


1.2 Requirements
1.LANhas an IPv4 server that now needs to be released to IPv6 addresses for access.IPv6 functionality involving NGAF is NAT's 6to4. At the same time,corresponding application layer protection should be done.



*2. Configuration Guide

2.1 NGAF Configuration


Step 1. Enable IPv6 and IPv4 support. IPv6function is turned off by default. Please check“enable IPV4 and IPv6 support”in [System] - [General Settings] - [Network ].Turning on this function willrestart the device.



Step 2: Defineinterface and zone.



Step 3: Define Network object.

Go to Objects > Network Objects > Network Objects


Step 4: Configure NAT64.
Go to Policy > NAT




Like this topic? Like it or reward the author.

Creating a topic earns you 5 coins. A featured or excellent topic earns you more coins. What is Coin?

Enter your mobile phone number and company name for better service. Go

RegiBoy Lv5Posted 17 Oct 2022 13:32
  
Please like if you like
Zonger Lv5Posted 17 Oct 2022 14:00
  
thanks for sharing
rivsy Lv5Posted 17 Oct 2022 14:13
  
thank you for this wonderful information
CLELUQMAN Lv4Posted 08 Dec 2022 17:09
  
Nice information. Thank you for sharing
Newbie517762 Lv5Posted 09 Dec 2022 09:47
  
Thanks for sharing.