Ping Error On Physical Interface

Fareid Radzi Lv1Posted 16 Mar 2023 20:51

Hi All. I need help. I have received PING ERROR on my NGAF5400 at eth5. Currently the eth5 port is set for my backup internet line. Since the error is there, I cannot switch my main internet line to the the backup line. I need help / advice to solve this matter. Thanks in advance.

CTI_JianJie has solved this question and earned 10 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

Check what the link state detection setting is, if the connection work when plug into the PC, try to ping in the PC if the IP address defined in the link state detection could be ping or not.

1.png (35.68 KB, Downloads: 834)

1.png
Is this answer helpful?
Faisal Piliang Posted 21 Mar 2023 14:04
  
IP address is configured. Dial-up status: When Link Mode: operating mode of the network interface, such as auto-negotiation.
Natsu Dragneel Lv3Posted 20 Mar 2023 17:14
  
Get support on tech team
BitCloud Lv3Posted 20 Mar 2023 17:10
  
Check the network and the subnet mask
isabelita Lv3Posted 20 Mar 2023 17:04
  
The network has the biggest share on the problem
Farina Ahmed Lv5Posted 20 Mar 2023 16:04
  
If it was working correctly previously (like ping was done correctly previously) then check with the cable or port. Sometimes we check higher issues where as their is a minor problem in the physical ethernet cable or port might be shutdown or got faulty.
Jhazz Lv3Posted 20 Mar 2023 15:51
  
Did you check the default settings of the IP and subnet mask?
Adonis001 Lv3Posted 20 Mar 2023 15:27
  
you may want to try swapping out the network cable
rivsy Lv5Posted 20 Mar 2023 14:59
  
Check the subnet mask if same to the primary and backup
faysalji Lv3Posted 20 Mar 2023 14:05
  
Last edited by faysalji 20 Mar 2023 15:12.

Check the settings for eth5, including the IP address, subnet mask, default gateway, and DNS servers, to ensure that they are correct and match the configuration of your backup internet connection.

If the settings appear to be correct, you may want to try swapping out the network cable or testing the connection with a different device to see if the issue is related to a physical problem with the port.

I Can Help:

Change

Moderator on This Board

11
7
5

Started Topics

Followers

Follow

1
3
5

Started Topics

Followers

Follow

0
4
5

Started Topics

Followers

Follow

67
20
3

Started Topics

Followers

Follow

3
14
3

Started Topics

Followers

Follow

1
137
3

Started Topics

Followers

Follow

Board Leaders