How to configure default vlan to other vlans will communicate each other

CLELUQMAN has solved this question and earned 20 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

Hi.
Inside the Policy>Access Control> Application Control.
Add a new policy , define your source and destination zone.
Is this answer helpful?
Newbie517762 Lv5Posted 30 Jan 2023 10:14
  
Thanks for your sharing !
Jhazz Lv3Posted 27 Jan 2023 11:16
  
You can configure it in the "Application Control" you can set it manually
Luih Miranda Lv3Posted 27 Jan 2023 00:55
  
Vlan is a broadcast domain . By default hosts in single Vlan communicates to each other . But host in different Vlans won't communicate to each other , to ensure communication between different Vlans host routing between Vlans is mandatory for Configuring routing between Vlan layer3 device is required
rivsy Lv5Posted 26 Jan 2023 14:53
  
You can check in the "Policies" tab under "Application Control"
RegiBoy Lv5Posted 25 Jan 2023 22:09
  
You just configure a trunk port then allow what vlans you desire.
Farina Ahmed Lv5Posted 25 Jan 2023 17:26
  
By default VLAN is called VLAN1 and you don't need any configuration to communicate VLAN1 OR Native VLAN  to other VLANs But if still the case and it required intervlan routing then the configuration will be the same as for other VLANs communication.

I Can Help:

Change

Moderator on This Board

11
7
5

Started Topics

Followers

Follow

1
3
5

Started Topics

Followers

Follow

0
4
5

Started Topics

Followers

Follow

67
20
3

Started Topics

Followers

Follow

3
14
3

Started Topics

Followers

Follow

1
137
3

Started Topics

Followers

Follow

Board Leaders