Natsu Dragneel Lv3Posted 27 Jan 2023 16:53
  
It is not supported yet.
BitCloud Lv3Posted 27 Jan 2023 16:50
  
NetFlow is based on 7 key fields:
1. Source IP address
2. Destination IP address
3. Source port number
4. Destination port number
5. Layer 3 protocol type (ex. TCP, UDP)
6. ToS (type of service) byte
7. Input logical interface
Naomi Lv3Posted 27 Jan 2023 16:35
  
No documentation for netflow
RegiBoy Lv5Posted 27 Jan 2023 14:35
  
Netflow is for Cisco only because it is proprietary. Maybe it is SFLOW.
FahmiAzlanMY Lv1Posted 27 Jan 2023 14:33
  
Last edited by FahmiAzlanMY 27 Jan 2023 16:54.

Thanks guys, I have contact support, they said netflow doesn't support at the moment.
There is no any roadmap for this.
Jhazz Lv3Posted 27 Jan 2023 14:00
  
Upon researching and reviewing the sangfor knowledge base site, there is no manual on the configuration guide for Netflow. You may seek help to your local sangfor provider for assistant right now. Since Netflow configuration and command is different from each brand and model (you cannot use the Netflow configuration guide for CISCO, HP and others).

NetFlow is based on 7 key fields:
1. Source IP address
2. Destination IP address
3. Source port number
4. Destination port number
5. Layer 3 protocol type (ex. TCP, UDP)
6. ToS (type of service) byte
7. Input logical interface
rivsy Lv5Posted 27 Jan 2023 13:55
  
Maybe will wait for the official Netflow configuration from Sangfor since it does not have right now
Farina Ahmed Posted 26 Jan 2023 13:44
  
It is not specifically shown for NGAF but you can follow these steps for NGAF. Configuration might vary a little bit from this but check NGAF GUI and do accordingly. I am sharing link for Palo Alto.

https://knowledgebase.paloaltone ... =kA10g000000ClJzCAK

I Can Help:

Change

Moderator on This Board

0
2
4

Started Topics

Followers

Follow

67
16
3

Started Topics

Followers

Follow

3
3
3

Started Topics

Followers

Follow

1
131
3

Started Topics

Followers

Follow

Board Leaders