syedjahanzaib Lv1Posted 30 Nov 2022 18:34
  
IAM is connected to Cisco Core Switch where all VLANs are configured. IAM ip is 192.168.10.1 which is on VLAN-1, Users ip is 10.10.10.10 which is connected with VLAN-10 . after adding routes at user/iam, BOTH can ping each other. I have made changes to switch port where IAM is connected and set it to TRUNK. is there any thing else that needs to be configured? what default gateway should be added for user in dhcp ? at user end when i run traceroute to 1.1.1.1 , it shows destination host unreachable on 2nd hop.
RegiBoy Lv5Posted 30 Nov 2022 18:23
  
If your Cisco Switch is your Core Switch, you can configure a trunk port on Cisco Switch to IAM so that it can see all the Vlan. The trunk port must allow all your existing vlan. Then the IAM is connected to the firewall for the uplink of the end users. The high level view of topology is Firewall>IAG>Switch

I Can Help:

Change

Moderator on This Board

15
21
3

Started Topics

Followers

Follow

Board Leaders