Endpoint secure on Hyper-V

Rapid PC Lv1Posted 2024-Mar-11 21:26

Hello everybody, i've recently started to deploy the Sangfor Endpoint secure to all of my customer. I'm using the 3.7.12 OVA version, and it works without any problem on Vmware ESXI. But not all of my customer use vmware as virtualization environment, some use hyper-v, and i can't make it work here. I can successfully install it, it boot correctly but then there's no way for me to open the console webpage (on the default ip 10.251.251.251), even using other vm on the same subnet.
is it mandatory to utilize Vmware or HCI as virtualization?
Thanks in advance, have a nice day

Siva has solved this question and earned 10 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

This is due to the NIC of the system is unable to up automatically.
You may access the Virtual Machine console and manually enable the interface. (ifconfig ethX up)
Note: The interface is not necessarily ethX, it could be enspX. (refer to /sys/class/net)

To access the backend, you may provide the QR code shown on the Virtual Machine console and send to tech.support@sangfor.com.
Is this answer helpful?
1000THR Lv1Posted 2024-Apr-04 15:36
  
Hi Rapid, what is the current network adapter configuration?
Probably it's set in NAT switch mode while the Endpoint Secure requires having a bridge network interface to communicate over the network.
I would also suggest comparing the Hyper-V VM network config with the ESXi network config as it could also be a problem of an unsupported NIC type due to missing drivers
Siva Posted 2024-Apr-29 11:34
  
This is due to the NIC of the system is unable to up automatically.
You may access the Virtual Machine console and manually enable the interface. (ifconfig ethX up)
Note: The interface is not necessarily ethX, it could be enspX. (refer to /sys/class/net)

To access the backend, you may provide the QR code shown on the Virtual Machine console and send to tech.support@sangfor.com.

I Can Help:

Change

Moderator on This Board

3
14
3

Started Topics

Followers

Follow

1
3
6

Started Topics

Followers

Follow

18
8
0

Started Topics

Followers

Follow

Trending Topics

Board Leaders