MTR Lv2Posted 26 Nov 2023 19:07
  
To set up a site-to-site VPN on your NGAF (Next-Generation Application Firewall) for the Head Quarters and Branch configuration, you can follow these general steps:

Configure the NGAF devices: Set up the NGAF devices at both the Head Quarters and Branch locations. Ensure that they are properly connected to the network and have the necessary configurations in place.

Create VPN profiles: Access the NGAF management interface and navigate to the VPN settings. Create VPN profiles for the site-to-site connection. You may need to specify the encryption algorithms, authentication methods, and other parameters according to your network requirements.

Configure IPsec settings: IPsec (Internet Protocol Security) is commonly used for site-to-site VPN connections. Configure the IPsec settings on both the Head Quarters and Branch NGAF devices. This includes defining the IPsec policies, specifying the local and remote subnets, and configuring the security associations.

Establish the VPN tunnel: Once the VPN profiles and IPsec settings are configured, initiate the VPN tunnel between the Head Quarters and Branch NGAF devices. This will establish a secure connection between the two locations.

Test the connectivity: After the VPN tunnel is established, test the connectivity between the Head Quarters and Branch networks. Ensure that you can access resources on both sides of the VPN and that the communication is secure.

Please note that the specific steps and configurations may vary depending on the NGAF model and firmware version you are using. It is recommended to refer to the NGAF documentation

I Can Help:

Change

Moderator on This Board

0
2
4

Started Topics

Followers

Follow

67
15
3

Started Topics

Followers

Follow

3
1
3

Started Topics

Followers

Follow

1
131
3

Started Topics

Followers

Follow

Board Leaders