isabelita Lv3Posted 23 Nov 2023 12:19
  
Below is a general guide for setting up a site-to-site VPN on Sangfor NGAF. Please refer to the official documentation or seek assistance from Sangfor support for the most accurate and updated information based on your NGAF version.

Prerequisites:
Access to Sangfor NGAF web interface.
Knowledge of the IP addresses and network configurations of the HQ and branch offices.
Site-to-Site VPN Configuration Steps:
Step 1: Log in to Sangfor NGAF Web Interface
Open a web browser and enter the IP address or hostname of your Sangfor NGAF device. Log in with the appropriate credentials.

Step 2: Navigate to VPN Configuration
Navigate to the VPN configuration section. This may be located under a "VPN" or "Security" menu. Specific menu names might vary based on the NGAF version.

Step 3: Create VPN Policy
HQ Configuration:

Create a new VPN policy for the HQ. Specify the local and remote IP addresses, encryption settings, and authentication details.
Define the local and remote networks that will be part of the VPN.
Set the IKE (Internet Key Exchange) parameters, such as the encryption algorithm and pre-shared key.
Branch Configuration:

Repeat the process for the branch office, ensuring that the local and remote details are appropriately configured.
Use the same pre-shared key as configured on the HQ side.
Specify the local and remote networks.

I Can Help:

Change

Moderator on This Board

0
2
4

Started Topics

Followers

Follow

67
14
3

Started Topics

Followers

Follow

3
0
2

Started Topics

Followers

Follow

1
131
3

Started Topics

Followers

Follow

Board Leaders