JoanaPatricia Lv2Posted 08 Nov 2023 16:36
  
Yes you should configure the L2 Cisco switch to aggregate links or combined links
Fuji12 Lv3Posted 08 Nov 2023 16:36
  
Ensure that the configuration on the Cisco switch matches the configuration on your HCI nodes. This includes the load-balancing method and other settings. Consistency is crucial for proper functioning.
babeshuka Lv3Posted 08 Nov 2023 16:37
  
Yes, By setting up EtherChannel on your Cisco switch, you'll optimize the use of the aggregated links and provide a more stable and efficient network connection for your HCI environment. Please consult your Cisco switch documentation or seek assistance from your network administrator if you are unfamiliar with the specific configuration steps for your switch model.
LucyHeart Lv3Posted 08 Nov 2023 16:37
  
You may maximize the utilization of the aggregated links and provide your HCI environment a more reliable and effective network connection by configuring EtherChannel on your Cisco switch. If you are unsure of the precise setup instructions for your switch model, please refer to your Cisco switch manual or ask your network administrator for help.
Jigen87 Lv3Posted 08 Nov 2023 16:38
  
After configuring EtherChannel on the switch and link aggregation on your HCI nodes, perform connectivity testing to ensure that traffic is being balanced across the aggregated links and that failover is working as expected.
Rica Cortez Lv2Posted 08 Nov 2023 16:38
  
Once your HCI nodes and the switch have been configured for link aggregation and EtherChannel, test connection to make sure failover is functioning as it should and that traffic is evenly distributed over the aggregated links.
jerome_itable Lv2Posted 09 Nov 2023 08:21
  
Yes, you do need to configure EtherChannel on the Cisco L2 switch to enable link aggregation between the Sangfor HCI nodes. This is because EtherChannel is the Cisco implementation of link aggregation, and it is necessary for the switch to recognize and manage the aggregated link.

Here are the steps on how to configure EtherChannel on a Cisco L2 switch:

    Identify the ports that you want to include in the EtherChannel.
    Create an EtherChannel bundle.
    Assign a channel group number to the EtherChannel bundle.
    Add the ports to the EtherChannel bundle.
    Configure the EtherChannel bundle to use LACP (Link Aggregation Control Protocol).

Once you have configured EtherChannel on the Cisco L2 switch, the Sangfor HCI nodes will be able to use link aggregation to increase the bandwidth and redundancy of their network connections.

I Can Help:

Change

Moderator on This Board

3
0
2

Started Topics

Followers

Follow

2
0
0

Started Topics

Followers

Follow

2
20
0

Started Topics

Followers

Follow

Board Leaders