mdamores Lv3Posted 01 Nov 2023 09:51
  
Based on the current firmware version, you may limit the bandwidth on an IPsec VPN in NGAF by imp,ementing QoS policies to control the traffic traversing the VPN tunnel. Steps might vary depending on the version, but you may refer to the general guidelines below:

- Access the NGAF Interface through the web interface or command-line interface (CLI).
- Check which VPN traffic you want to limit. you may also specify the source and destination IP address, ports, or specific apps.
- specify QoS policy
- create classification policy that matches VPN traffic that you want to limit. You may also define access rules matching the specified source or destination IP addresses, ports, or application traffic. you can also create a traffic shaping policy specifying the bandwidth limits per second. Apply the traffic shaping policy to specific interface to where the VPN traffic passes through to ensure that the policy is enforced on the VPN traffic.
- save and apply the changes.
- testing and monitoring

I Can Help:

Change

Moderator on This Board

0
2
4

Started Topics

Followers

Follow

67
14
3

Started Topics

Followers

Follow

3
0
2

Started Topics

Followers

Follow

1
131
3

Started Topics

Followers

Follow

Board Leaders