jerome_itable Lv2Posted 31 Oct 2023 16:41
  
Yes, eth0 can be used as a heartbeat in Sangfor NGAF HA mode.

To do this, you will need to configure the following:

    On the primary NGAF device, go to System > High Availability and enable HA mode.
    Enter the IP address of the secondary NGAF device in the Peer IP Address field.
    Select eth0 from the Heartbeat Interface drop-down menu.
    Click Save.

On the secondary NGAF device, configure the following:

    Go to System > High Availability and enable HA mode.
    Enter the IP address of the primary NGAF device in the Peer IP Address field.
    Select eth0 from the Heartbeat Interface drop-down menu.
    Click Save.

Once you have configured both devices, they will automatically form an HA cluster and begin sending heartbeats to each other over eth0. If one of the devices fails, the other device will take over and continue to provide firewall and other services.

I Can Help:

Change

Moderator on This Board

0
2
4

Started Topics

Followers

Follow

67
14
3

Started Topics

Followers

Follow

3
0
2

Started Topics

Followers

Follow

1
131
3

Started Topics

Followers

Follow

Board Leaders