Farina Ahmed Posted 15 May 2023 14:03
  
To implement InterVLAN routing on Sangfor devices, you can follow these step-by-step configurations:

Access Sangfor Device Management Interface: Log in to the Sangfor device management interface using the appropriate credentials.

Create VLANs: Configure the VLANs you want to use for InterVLAN routing. This typically involves specifying the VLAN IDs, VLAN names, and associated subnets for each VLAN. Ensure that the VLANs you create are distinct and do not overlap.

Configure VLAN Interfaces: Assign IP addresses to the VLAN interfaces to enable routing between the VLANs. Each VLAN will have its own virtual interface with an IP address within its respective subnet.

Enable InterVLAN Routing: Enable InterVLAN routing on the Sangfor device. This setting allows traffic to flow between the different VLANs.

Configure Routing Protocols (Optional): If you want to use dynamic routing protocols, such as OSPF or RIP, configure the desired routing protocol on the Sangfor device. This step is optional and can be skipped if you prefer to use static routes.

Add Static Routes (If not using dynamic routing): If you are not using dynamic routing protocols, configure static routes on the Sangfor device. Add routes to each VLAN subnet so that the device knows how to reach the different VLANs.

Configure VLAN Access Control (Optional): If you want to implement access control between VLANs, configure VLAN access control rules on the Sangfor device. These rules allow you to control which traffic is permitted or denied between VLANs.

Test InterVLAN Connectivity: Once the configuration is complete, test the InterVLAN connectivity. Try pinging devices in different VLANs to verify that the traffic is correctly routed between them.

It's important to note that the specific steps and options available may vary depending on the model and firmware version of your Sangfor device. Refer to the documentation or contact Sangfor support for detailed instructions tailored to your specific device.

Additionally, make sure to carefully plan your network design, including subnet addressing, VLAN assignments, and routing requirements, to ensure a smooth implementation of InterVLAN routing on Sangfor devices.

I Can Help:

Change

Moderator on This Board

0
2
4

Started Topics

Followers

Follow

67
14
3

Started Topics

Followers

Follow

3
0
2

Started Topics

Followers

Follow

1
131
3

Started Topics

Followers

Follow

Board Leaders