Newbie098542 Posted 19 Oct 2022 12:35
  

Follow the wizard prompts.  You can use the Wizard if your configuration is just a basic configuration
Fisher Lv2Posted 19 Oct 2022 12:16
  
Because in Sangfor NGAF the zone just for binding to the interfaces.
Franky Lv3Posted 19 Oct 2022 12:08
  
use the Wizard if your configuration is just a basic config
Gomu Lv2Posted 19 Oct 2022 11:20
  
address dashborad-svr 10.252.252.17/32;
                address dns00-svr 10.252.252.4/32;
                address dns01-svr 10.252.252.5/32;
                address idea-svr 10.252.252.30/32;
                address idea-web2-svr 10.252.252.31/32;
                address idea-web1-svr 10.252.252.32/32;
                address pjj-svr 10.252.252.34/32;
                address hosting-svr 10.252.252.98/32;
Randolfy Lv2Posted 19 Oct 2022 10:39
  
Do it in GUI Wizard if its basic command.
Jay Taruc Lv2Posted 19 Oct 2022 10:21
  

Use configuration wizard
KarenD Lv2Posted 19 Oct 2022 10:16
  
Easy way to  access to GUI Juniper
Nami Lv2Posted 19 Oct 2022 10:06
  
it would be easier if you will do it in Juniper's GUI than CLI
Racoon Lv2Posted 19 Oct 2022 10:02
  
Do not over extend it to CLI.
Newbie517762 Lv5Posted 19 Oct 2022 09:54
  
Pls try to Wizard for basic configuration.

I Can Help:

Change

Moderator on This Board

0
2
4

Started Topics

Followers

Follow

67
14
3

Started Topics

Followers

Follow

3
1
2

Started Topics

Followers

Follow

1
131
3

Started Topics

Followers

Follow

Board Leaders