setting is simply a basic configuration

Use GUI instead

f your setting is simply a basic configuration, you can use the GUI

Use Wizard if you do basic configuration

You may use the NAT wizard to guide you to the process

Just try to Wizard for basic configuration.

You can use the Wizard if your configuration is just a basic one.

You can use the Wizard if your configuration is just a basic one.

Its  complicated when you use CLI instead of GUI but have almost same output

rule-set rs-DA {
                from zone DC-A ;
                to zone internet;
                rule DNS-4-source-nat-rule {
                    match {
                        source-address 10.252.252.4/32;
                    }