Erickson Santos Lv1Posted 14 Oct 2019 15:35
  
There are 2 ways that I know also.

1. Using Layer 3 (Route) Interface. Create mutiple sub-interfaces under 1 LAN layer 3 interface and assign corresponding VLAN number.

2. Using Layer 2 (Bridge) Interface. Create layer 2 (bridge) interface and set the link type to TRUNK and set the allowed VLAN (e.g. vlan 2-10). Then create VLAN interfaces, set ip addresses and vlan number.

Using these two options, there will be no routing needed as the VLANs will be directly connected to each other.

I Can Help:

Change

Moderator on This Board

1
131
3

Started Topics

Followers

Follow

18
8
0

Started Topics

Followers

Follow

Board Leaders