Newbie290036 Lv2Posted 03 May 2024 17:31
  
Configuring failover between two WAN links on Sangfor IAM (Internet Access Management) is a common requirement to ensure network reliability and continuity.

1. Log in to the Sangfor IAM web console using your administrator credentials.

2. Navigate to the WAN Configuration section, usually found under Network Settings or a similar menu option.

3. Locate the settings for WAN links and look for options related to configuring multiple WAN connections or failover.

4. Add both of your WAN links and ensure they are properly configured with the correct IP addresses, gateway, and other necessary details.

5. Look for an option to set up load balancing or failover between the two WAN links. You may need to specify the primary and secondary WAN links for failover scenarios.

6. Configure the failover settings according to your requirements. Typically, you can set up a priority order for the WAN links or specify conditions under which failover should occur (such as link failure detection).

7. Save your settings and test the failover functionality by disconnecting one of the WAN links and observing how the Sangfor IAM device switches over to the backup link.

I Can Help:

Change

Moderator on This Board

15
21
3

Started Topics

Followers

Follow

Board Leaders