1/4
Franky  Posted 2022-Oct-19 12:08
  
use the Wizard if your configuration is just a basic config
Fisher  Posted 2022-Oct-19 12:16
  
Because in Sangfor NGAF the zone just for binding to the interfaces.
Newbie098542  Posted 2022-Oct-19 12:35
  

Follow the wizard prompts.  You can use the Wizard if your configuration is just a basic configuration
Carrot  Posted 2022-Oct-19 12:39
  
rule-set rs-DA {
                from zone DC-A ;
                to zone internet;
                rule DNS-4-source-nat-rule {
                    match {
                        source-address 10.252.252.4/32;
                    }
Brooker  Posted 2022-Oct-19 12:50
  
Its  complicated when you use CLI instead of GUI but have almost same output
KatAndres Lv2  Posted 2022-Oct-19 17:05
  
You can use the Wizard if your configuration is just a basic one.
chepadrinao Lv3  Posted 2022-Oct-19 17:12
  
You can use the Wizard if your configuration is just a basic one.
Fverdillo  Posted 2022-Oct-19 17:16
  
Just try to Wizard for basic configuration.
jpbaltazar Lv2  Posted 2022-Oct-20 07:38
  
You may use the NAT wizard to guide you to the process
Deorwine Lv2  Posted 2022-Oct-20 13:32
  
Use Wizard if you do basic configuration

I Can Help:

Change

Moderator on This Board

1
160
3

Started Topics

Followers

Follow

1164
250
101

Started Topics

Followers

Follow

Board Leaders