1/3
Maqsood9090 Lv3  Posted 2026-Oct-19 12:04
  
B. IGMP Snooping
Muhammad Shiraz Lv3  Posted 2026-Oct-19 12:07
  
B. IGMP Snooping
Muhammad Abid Lv3  Posted 2026-Oct-19 12:11
  
B. IGMP Snooping            
Syed Majid Lv1  Posted 2026-Oct-19 12:27
  
For HCI like VxRail / vSAN Ready Nodes:Hosts are wired Active/Standby - not Active/Active.They use vSwitch failover, not hashing.Usually a server connects to the pair of VLT switches with a LACP LAG. However, LACP is not used with VxRail nodes since the nodes are configured with a virtual switch with active and standby adapters. downloads.dell.comDell official planning guide:do not enable LAG or protocols such as LACP and Ether Channel on any switch ports that are connected to VxRail node ports before initial implementation. Doing so results in VxRail initial implementation to fail. dell.comThat applies to all HCI networks before day-1 including:ManagementvSAN / HCI storagevMotionVXLAN / NSX VTEPWhat you must enable for VXLAN is Jumbo Frame MTU 9000 / 1600+.What you must disable is:A. LACP and D. Link aggregation / EtherChannel / Port-Channel - they are the same thing.If the exam allows only one choice, choose. Link aggregation - and specifically A. LACP
Mike Lee Lv2  Posted 2026-Oct-19 12:35
  
B. IGMP Snooping
Kashif R Lv2  Posted 2026-Oct-19 12:36
  
B. IGMP Snooping.
victormeidy Lv1  Posted 2026-Oct-19 12:36
  
D. Link aggregation
BrianTang Lv2  Posted 2026-Oct-19 12:43
  
B. IGMP Snooping
Newbie900829 Lv2  Posted 2026-Oct-19 12:54
  
*B. IGMP Snooping*
AR Lv3  Posted 2026-Oct-19 12:55
  
B. IGMP Snooping