RegiBoy Lv5Posted Mar-13-2023 16:53
  
By default it is not enable first so you must enable it manually. You can go to Menu > System > Logs and Alarms > Syslog Server  -  then input the IP address of the Log Server you want to receive the logs
Farina Ahmed Lv5Posted Mar-13-2023 17:39
  
Logs dont drive means check with your total EPS license and storage capacity. If it is capable of storing too many other logs.
CLELUQMAN Lv4Posted Mar-14-2023 12:51
  
It is possible. for your issue, check that the correct IP address and port number are being used for the syslog server in Sangfor HCI's configuration.
sumran Lv2Posted Mar-18-2023 21:02
  
please follow these steps
Menu > System > Logs and Alarms > Syslog Server
and make sure you can ping the server if logs are not appearing then please check the configuration setting again .
Taha Lv2Posted Mar-18-2023 21:08
  
please check the configuration setting and try again

I Can Help:

Change

Moderator on This Board

135
80
24

Started Topics

Followers

Follow

Board Leaders

NyxZale...

Weekly Sharers

Newbie5...

Weekly Questioners