how to configure firewall to use physical interface to be use as Lan

Newbie517762 has solved this question and earned 10 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

HiHi,

Please find the attached file - NGAF Setup Simple Guide for your easy Ref:
NGAF Setup Simple Guide-7.3.pdf (1.92 MB, Downloads: 97)
Is this answer helpful?
Prosi Lv3Posted 14 Jun 2024 09:51
  
Hi,

Below is the network topology

To achieve the above, we need to deploy a front-end firewall or switch to do policy routing based on source IP address, enabling the Sangfor WOC to forward the packets from varying source IP addresses to different outlets of the network. Besides, perform the following steps to complete the related configuration.
Configure deployment mode for the HQ WAN Optimization Controller (WOC).
Go to the System > Network > Deployment tab; select service mode VPN and Acceleration and deployment mode Single Arm; configure the LAN interface IP address and two other IP addresses (please be noted that IP addresses configured for the LAN interface must be on a same network segment).
Newbie517762 Lv5Posted 14 Jun 2024 14:06
  
HiHi,

Please find the attached file - NGAF Setup Simple Guide for your easy Ref:
NGAF Setup Simple Guide-7.3.pdf (1.92 MB, Downloads: 97)
Farina Ahmed Lv5Posted 14 Jun 2024 17:10
  
Go to the network settings and identify the physical interface you wish to configure as LAN. Assign it a static IP address within the desired LAN subnet. Configure DHCP settings if the firewall will manage IP assignments, ensuring it covers the subnet range. Apply necessary security policies and rules to control traffic between the LAN and other network zones. Save and apply the configuration changes.
Moneeb Lv2Posted 15 Jun 2024 14:56
  
Open the firewall and click on the network option at top.

Then on left click on interfaces and the click on any ETH interface you want to configure for LAN.

In Zone option, create a new Zone as LAN and select it. Rest of the settings depends on your requirements.

I have attached the example snapshot for your reference.

LAN.jpg (105.26 KB, Downloads: 92)

LAN Settings

LAN Settings

I Can Help:

Change

Moderator on This Board

11
7
5

Started Topics

Followers

Follow

1
3
5

Started Topics

Followers

Follow

0
4
5

Started Topics

Followers

Follow

67
20
3

Started Topics

Followers

Follow

3
14
3

Started Topics

Followers

Follow

1
137
3

Started Topics

Followers

Follow

Board Leaders