firmware updater

zmulles Lv1Posted 05 May 2022 13:25

Last edited by zmulles 05 May 2022 13:29.

Last edited by zmulles 05 May 2022 13:28.

Last edited by zmulles 05 May 2022 13:26.

Good day erveryone , I have been trying to reset my ngaf , I have downloaded firmware updater ,But this what i got
any suggestions? and information are very much appreciated thanks,,

rivsy has solved this question and earned 20 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

Last edited by rivsy 12 May 2022 10:46.

It is recommended when upgrading firmware that you update it 1 version higher not 2 to 3 version higher (example if your firmware is version 6, then you want to upgrade to version 8, you must upgrade to version 7 first before going to version 8).  

And check the following condition if meet:
1. Check if the upgrade license is valid
2. Check if the NGAF deployed in HA (High Availability mode) is disabled (enable this after upgrade)
3. Check if the custom patch or KB patch installed on the NGAF
4. Check if the NGAF hardware can support the firmware
5. Check in the Sync Options if the synchronization is disable
Is this answer helpful?
Imran Tahir Lv4Posted 19 May 2022 12:44
  
Enable ssh fist then give the right to user factort level
Imran Tahir Lv4Posted 18 May 2022 10:51
  

informative
zmulles Lv1Posted 17 May 2022 08:46
  
thank you all for the infos and keypoints, i can now access my ngaf , after running the updater and resetting the unit ,I tried to open the web UI to a different browser and it showed the login page, maybe there is conflict with my google chrome... Thanks again
Osama Muhammad Lv3Posted 16 May 2022 23:01
  
zmulles,

You have to enable ssh first on the interface you want to connect it for.
Liew Lv2Posted 13 May 2022 11:18
  
Good day! If you are connecting to 10.251.251.251, kindly go to NGAF web UI zone module, assign the management interface into one zone, and enable SSH for that zone. Furthermore, kindly ensure the keyin password is the correct admin password.

I Can Help:

Change

Moderator on This Board

11
7
5

Started Topics

Followers

Follow

1
3
5

Started Topics

Followers

Follow

0
4
5

Started Topics

Followers

Follow

67
20
3

Started Topics

Followers

Follow

3
14
3

Started Topics

Followers

Follow

1
137
3

Started Topics

Followers

Follow

Board Leaders