integrated SSL VPN with nComputing RX300

Karolus Thias Lv1Posted 14 Jul 2020 10:13

I am deploying SSL VPN and one of the clients is using RXC 300 nComputing, where nComputing only supports the use of OpenVPN, Open Connect, and PPTP. I tried to use the open connect and PPTP settings but it didn't work. are there any suggestions regarding this matter?

Newbie280530 has solved this question and earned 10 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

"I tried to use the open connect and PPTP settings but it didn't work.", may I know are you enable the PPTP on SSL VPN? If yes but still not working, then you may send in an email to tech.support@sangfor.com for Support Engineer to assist you on this issue.
Is this answer helpful?
Mei Ying Lv1Posted 13 Sep 2022 09:34
  
As long as the OS is supported then it should be no issue.
You can refer to the SSLVPN compatibility list:
https://community.sangfor.com/pl ... 6408&highlight=
Pat Lv4Posted 14 Jul 2022 15:08
  
you will not be able to use nComputing thru OpenConnect and PPTP in NGAF since it was not supported by NGAF.
Rhebie Lv3Posted 14 Jul 2022 08:42
  

Please check the policy settings and logs to better understand what's the problem that is causing the issue.
jetjetd Lv5Posted 13 Jul 2022 19:22
  
Last edited by jetjetd 13 Jul 2022 19:24.

Due to security concerns, Sangfor did not include the OpenConnect and PPTP in NGAF. Only supported in Sangfor NGAF is Sangfor's own SANGFOR VPN, IPSEC VPN and SSL VPN.
Faisal P Posted 13 Jul 2022 15:06
  
If your firewall support, then move Client VPN tunnel or deploy OpenVPN server
Imran Tahir Lv4Posted 12 Jul 2022 20:51
  
Current polich checking
rivsy Lv5Posted 12 Jul 2022 11:41
  
Please check the policy setting if the NComputing is whitelist
naomivillamor Posted 11 Jul 2022 16:28
  
Review the policy you made in your firewall.
regidorreyes Lv5Posted 11 Jul 2022 15:43
  
You can check the logs for the possible cause. Also check the side of Ncomputing if there missing settings or need to enable/disable options.

I Can Help:

Change

Board Leaders