Link Load Balancer

Newbie603645 Lv1Posted 2024-Dec-18 01:27

How do I configure Link Load Balancer?

fuadmahbubun has solved this question and earned 10 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

Hi You Can try using Policy Based Route if you have minimum two internet connection (ISP)

for detail step and which load balancing methode you want to use, please see guidance here.

This topic contains more resources

You must log in to download or view the file. Not registered yet? Register

x
Is this answer helpful?
Muhammad Shiraz Lv2Posted 2024-Dec-19 12:23
  
To configure Link Load Balancer, log in to the web console and go to the Link Load Balancer settings. Add your WAN links by specifying the interface, IP address, gateway, and bandwidth.
Choose a load balancing strategy like round robin or bandwidth based.
Set health checks (e.g. ping or HTTP) to monitor link status. Enable failover to switch traffic if a link goes down. Save and apply the settings, then test to ensure everything works. Use the monitoring dashboard to check performance and adjust if needed.
Clarence Roque Lv2Posted 2024-Dec-18 08:55
  
Last edited by Clarence Roque 2024-Dec-18 08:59.

Hello you can try this guide

Go to Network > Routes > Policy-Based Routes > select Link Load-Balancing Route then select the 2 links you want to load balance you can choose what load balancing method you want.

I Can Help:

Change

Moderator on This Board

11
8
5

Started Topics

Followers

Follow

1
3
6

Started Topics

Followers

Follow

0
4
5

Started Topics

Followers

Follow

67
20
3

Started Topics

Followers

Follow

3
14
3

Started Topics

Followers

Follow

1
139
3

Started Topics

Followers

Follow

Board Leaders