Configuring Extra Syslog Servers When Connecting FortiGate to XDR
  

Newbie267391 Lv1Posted 2026-Jun-25 21:26

Question. Only one Syslog server can be configured on the Forti interface. How to handle it if the slot is already occupied?

An additional Syslog server can be configured via the CLI command line.

Detailed steps: Access the CLI first, then run the "end" command to exit Global mode.
Configure the new syslog server line by line as shown in the figure below:

config log syslogd2 setting
    set status enable
    set server "10.10.10.10"  //Replace with Broker IP
    set mode udp
    set port 514
End
Finally, run get log syslogd2 setting to view the configuration results (the configuration will not be displayed on the UI page)

468486a3d2af1af879.png (408.91 KB, Downloads: 0)

468486a3d2af1af879.png

Like this topic? Like it or reward the author.

Creating a topic earns you 5 coins. A featured or excellent topic earns you more coins. What is Coin?

Enter your mobile phone number and company name for better service. Go

Moderator on This Board

1027
213
99

Started Topics

Followers

Follow

Trending Topics

Board Leaders