Hello,

I'm creating SNMP monitoring for my HCIs.

I enabled HCI, but it seems to be enabled only on the controller node. When I make SNMP requests to the controller node's IP address, I receive a response, but when I make them to the non-controller node, I don't. Should I also enable SNMP on the non-controller node?

In the MIB documentation for SNMP HCI, I see that some parameters are listed as not accessible (e.g., Storage Index). What does "not accessible" mean?

Is there clearer documentation? Who should I contact?

Thanks

By solving this question, you may help 792 user(s).

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

I Can Help:

Change

Board Leaders

NyxZale...

Weekly Sharers

Newbie5...

Weekly Questioners