NewbieD Posted 2024-Dec-29 22:59
  
Yes, you do need to configure EtherChannel on the Cisco L2 switch to enable link aggregation between the Sangfor HCI nodes
EHern Posted 2024-Dec-29 23:01
  
Yes, you do need to configure EtherChannel on the Cisco L2 switch to enable link aggregation between the Sangfor HCI nodes
NewbieC Lv3Posted 2024-Dec-29 23:02
  
Yes, you do need to configure EtherChannel on the Cisco L2 switch to enable link aggregation between the Sangfor HCI nodes
Denz Posted 2024-Dec-29 23:17
  
Yes, you do need to configure EtherChannel on the Cisco L2 switch to enable link aggregation between the Sangfor HCI nodes
Newbie517762 Lv5Posted 2024-Dec-30 08:47
  
Yes, it can support the LACP.
Abdul Rahman Lv2Posted 2025-Dec-16 00:40
  
Yes, Sangfor's non-storage links (Management and Production interfaces) fully support LACP (IEEE 802.3ad) for link aggregation, and it's actually the recommended configuration for production environments.