Sangfor Community»Categories Cyber Security IPSec/SSL VPN Assistance Needed: Configuring Specific Route for Se ...

Assistance Needed: Configuring Specific Route for Server IP x.x.x.x via eth3 on NGAF 8.0.26

views: 90663 | comments: 4 | added to Favorites 0
Lights on | 提示:支持键盘翻页<-左 右->
    组图打开中,请稍候......
Created: Feb-18-2025 22:14

Summary:

Dear Sangfor Support Team, I hope this message finds you well. I am currently using a Sangfor NGAF 8.0.26 firewall, and I need assistance with configuring a specific routing rule. My goal is to ensu ...

Reply

AR Posted Feb-20-2025 12:26
Hello, these are the steps:


Enter your admin login information to access the NGAF online interface.

Go to Interfaces > Network > Zones. Make sure the zones to which your LAN and WAN interfaces are assigned are correct.

Select Static Routes under Policies > Routing. To build a new static route, click "Add".

Set up the static route:

Zone of Source: LAN

Destination Network: the server's IP address (x.x.x.x)

Interface of Destination: eth3

Gateway: Eth3's default gateway

Make sure the rule is activated and save the configuration.
Newbie201207 Posted Feb-19-2025 15:54
Hi Enrico,
I hope this message finds you well.
I am currently using Sangfor NGAF 8.0.26 , and I am facing an issue while attempting to configure a static route. When I try to add a new static route, I receive the following error:
"Error: Route with this destination and metric already exists!"

Enrico Vanzetto Posted Feb-19-2025 15:44
Hi,
here's the steps:

Log in to the NGAF web interface using your admin credentials.

Navigate to Network > Interfaces > Zones. Ensure that your LAN and WAN interfaces are correctly assigned to their respective zones.

Go to Policies > Routing > Static Routes. Click on "Add" to create a new static route.

Configure the static route:

Source Zone: LAN

Destination Network: IP address of the server (x.x.x.x)

Destination Interface: eth3

Gateway: Default gateway for eth3

Save the configuration and ensure the rule is active.