Endpoint secure on Hyper-V
Hello everybody, i've recently started to deploy the Sangfor Endpoint secure to all of my customer. I'm using the 3.7.12 OVA version, and it works without any problem on Vmware ESXI. But not all of my customer use vmware as virtualization environment, some use hyper-v, and i can't make it work here. I can successfully install it, it boot correctly but then there's no way for me to open the console webpage (on the default ip 10.251.251.251), even using other vm on the same subnet.is it mandatory to utilize Vmware or HCI as virtualization?
Thanks in advance, have a nice day Hi Rapid, what is the current network adapter configuration?
Probably it's set in NAT switch mode while the Endpoint Secure requires having a bridge network interface to communicate over the network.
I would also suggest comparing the Hyper-V VM network config with the ESXi network config as it could also be a problem of an unsupported NIC type due to missing drivers This is due to the NIC of the system is unable to up automatically.
You may access the Virtual Machine console and manually enable the interface. (ifconfig ethX up)
Note: The interface is not necessarily ethX, it could be enspX. (refer to /sys/class/net)
To access the backend, you may provide the QR code shown on the Virtual Machine console and send to tech.support@sangfor.com.
page:
[1]