Config Eth0 is WAN port

Newbie099828 Lv1Posted 23 Nov 2019 10:01

Hi, I have NGAF L4170, so i config eth1 like WAN, eth2 is LAN port, so now i have 1 more line internet, I want config eth0 ( managment port ) is WAN port together with eth1. pls guide to me, thank you so much.

Park Bo Gart has solved this question and earned 20 coins.

Posting a reply earns you 2 coins. An accepted reply earns you 20 coins and another 10 coins for replying within 10 minutes. (Expired) What is Coin?

Enter your mobile phone number and company name for better service. Go

You can use Eth0 as WAN port for another ISP connection. Here is the list that you should check regarding internet connectivity:
1. Interface configuration
2. Zone configuration
3. Routing (default static route)
4. Source NAT (LAN to WAN)
5. Application control (allow policy LAN to WAN)

It is good to check also the IP configuration of the workstations:
1. IP address
2. Subnet mask
3. Gateway
4. DNS IP

Hope it helps!
Is this answer helpful?
Newbie191628 Lv2Posted 27 Nov 2019 10:58
  
HI, the eth0 port is not able to be condifugre as WAN port. You can configure WAN in other port except eth0. One more thing you need to take note is you line that supported by your license.
sai Lv1Posted 28 Nov 2019 17:07
  
Hi, try to configure the eh0 10.251.251.251/24 under this ip enter the public ip, if its not working try configure the eth 1 into WAN and eth 0 Lan
Park Bo Gart Lv1Posted 06 Dec 2019 22:28
  
You can use Eth0 as WAN port for another ISP connection. Here is the list that you should check regarding internet connectivity:
1. Interface configuration
2. Zone configuration
3. Routing (default static route)
4. Source NAT (LAN to WAN)
5. Application control (allow policy LAN to WAN)

It is good to check also the IP configuration of the workstations:
1. IP address
2. Subnet mask
3. Gateway
4. DNS IP

Hope it helps!

I Can Help:

Change

Moderator on This Board

0
14
0

Started Topics

Followers

Follow

Board Leaders